Diamondback 510Ic, Руководство пользователя

Страница: 12 / 40

10
ASSEMBLY INSTRUCTIONS
• Insert the handlebar/stem assembly into the receiver on
the main frame, paying care not to pinch the wire harness
connector (B-13).
• Loosen the stem height adjuster knob (G-15) with two or
three counter-clockwise rota ons. Adjust the stem/handlebar
assembly to the lowest posi on by pulling outward on the
knob to disengage the pop-pin. If the stem assembly does not
drop, loosen the knob further and pull outward on the knob
again. Repeat these steps again if necessary.
• Remove the four console fi xing screws (A-1) from the back of
the Console (A) and set them aside.
• Plug the upper wire harness connector (B-13) and the Heart
Rate Console Wire (B-11) into the matching connectors on the
back of the Console (A). Make sure both connec ons are
fi rmly
connected and click into posi on.
• Posi on the console above the moun ng plate located on
the Handlebar Mast (B). Be careful feeding excess wires into
the opening on the Handlebar Mast (B) while posi oning the
console.
• Reinstall the four (4) fi xing screws (A-1) through the underside
of the plate and into the console. Tighten the four screws only
a er all four have been started by hand.
• Install the Water Bo le Cage (G-1) using the 2 Water Bo le
Cage Assembly Screws (G-13). Insert Water Bo le (G-2) into
Water Bo le Cage (G-1).