7
3 0 0 S E R I E S O W N E R’ S M A N U A L
300U Assembly Instructions
Frame and Seat Assemblies
1.
Place the unit and all accompanying parts in a
clean, flat, and open space.
2.
Attach the Transport Bar to the Front of the Frame
using two M10 x 20mm bolts.
3.
Attach the Stabilizer Bar to the rear of the Frame
using two M10 x 20mm bolts.
4.
Slide the Seat Post in place on the frame and
screw in the Release Knob to hold it in place. Let
go of the Release Knob so that it’s pin will go into
one of the Post’s adjustment holes and then turn
the Knob clockwise to lock it in place.
5.
Place the Seat on the rod at the top of the Seat
Post. Adjust the seat so that it is flat and pointing
forward and then tighten the nuts on the Seat’s
bottom simultaneously using two wrenches.
Console Mast Assembly
1.
Hold up the Console Mast with the tube end facing
down and slide the Console Mast Cover onto it
as far as possible, with the tabs facing down.
2.
Hold the Console Mast up slightly above its
mounting post on the front of the Frame. Hook
the Tension Cable together and position the
connectors so that the cable is fixed securely.
Attach the wire in the Mast to the wire in the post.
3.
Slide the Mast onto the mounting post.
NOTE: Be careful not to pinch the wire while doing
this, doing so could cause the unit to malfunction.
Attach the Mast to the mounting post using four
M8 x 15mm bolts with four M8 arc washers (bent)
on the front and back and two M8 x 15mm bolts
with two M8 flat washers on the sides. Carefully
snap the Console Mast Cover into place on the
Frame.
4.
Align the Handlebar with its post near the top of
the Console Mast so that only one bolt hole is
facing upward. Feed the wire from the Handlebar
up through the top of the Console Mast. Slide
the handlebar onto the Console Mast while pulling
gently on the wire to take up the slack. Attach
the Handlebar to the Console Mast using three
M8 x 15mm bolts and three M8 flat washers.
Console Assembly
1.
Hold the Console up to the top of the Console
Mast and attach the two wires from the top of the
Mast to the back of the Console. Raise the
Console to the front of the Mast and slide the slot
in the back of the Console onto the top of the
Mast. While sliding the Console on, feed the slack
in the wires into the Mast.
NOTE: Be careful not to pinch the wires while
doing this, doing so could cause the unit to
operate incorrectly.
2.
Once the Console is in place on the Mast, attach
it in place using four M5 x 15mm bolts.
Pedal Assembly
1.
Use a crescent wrench to firmly affix the pedals
to the cranks.
2.
The left and right pedals are different and are
denoted as right or left on the bottom of each
pedal.
NOTE: Left pedal threads counter-clockwise.
3.
Retighten cranks after approximately 10 hours of
use.
