Planetary mixer TEKNO 40 - 60
23
SECTION B POINT 3
START-UP, USE AND ADJUSTMENTS
START-UP, USE AND ADJUSTMENTS
IMPORTANT WARNINGS !
Before starting the machine, the following precautions must be taken:
1.
Check that the machine voltage, specified on the identification plate on page 5, corresponds to the line
voltage of the socket you are using. If not, contact the supplier or manufacturer and do not connect up.
2.
Check that when the bowl lowering button is pressed, the bowl moves down and not up; ensure that
during the work cycle the tool rotates in the direction indicated by the arrow on the tool holder. If not,
press the stop button “9”, make sure you have set the external power supply switch to “0” and invert the
two wires R and S as shown in Fig. 16.
The following pages contain figures and keys to help illustrate the start-up sequences.
CAUTION ! Never fill the bowl beyond the capacity indicated by the manufacturer as this can seriously
damage the machine drive system.
The manufacturer accepts no liability for any damage caused by failure to observe the above instruction.
Emergency situations
If operator safety is endangered by the moving parts of the machine (tool, bowl, drive components), the
machine must be stopped as quickly as possible, in one of the following ways:
-
by disconnecting the power supply by setting the on-
board master switch to position “0” or by setting the
external power supply switch to “0”;
-
by pressing the STOP push-button.
