12
SG03371
5. FUNCTIONING / MANIPULATION
a) Installation / assembly
:
- Unpack carefully the appliance from its packaging
- Place the equipment on a stable surface.
- Install the machine in a clean, ventilated place, far away from heating sources (radiators, sun
lights…)
- Never place the device near a wall or near a partition makes of combustible materials even if it is
very well isolated.
- A distance of 10 cm from the partition or the wall is considered enough.
- Remove the protective film from the appliance.
b) First starting:
First cleaning
Clean the machine before its first use (see 6. Cleaning)
Connection to the main water supply
- Connect the drinking fountain on a stop valve with a male thread 15/21.
Minimal pressure: 0.6 bar. Maximal pressure: 6 bars
- The water evacuation circuit must be conceived to avoid any return of liquid waste.
Starting
- Open the stop valve and purge the drinking fountain by pressing on the control lever of the filler
glass. Adjust the flow thanks to the visible adjusting screw on the back part of the fountain.
- Adjust the flow of the water jet tap to have a suitable trajectory.
- Switch on when there is no more air in the circuit.
Connection of the device
- Check that the tension and the frequency of the electricity network suit to the values indicated on
the descriptive plate.
- Check that neither the cord nor the plug are damaged
- Make sure that every control knob is positioned on 0.
- Unwind completely the electric power cable and connect it in a normalised plug with the earth.
- The device is connected.
NB: in case of connection of the device in a plug without earth protection or directly on the electricity
network, confide its connection to a qualified person
c) Breakdown / repair:
In case of breakdown or of damaged part, please call your after-sales service and confide any technical
operation to qualified person.
When you contact the after-sales service of your distributor or your store, give him the complete reference
of your device (commercial name, type and serial number). This information appears on the visible
descriptive plate behind the device.
