3. Place billboard (
A
) over holes on handle (viewing from
front of unit). Push the tree clips (
B
) into the holes (
C
)
until they sit flat against the billboard.
4. Insert spray gun holder wireform (
A
) through hole on
left side of handle (viewing from front of unit). Hold
wireform in place and attach a plastic knob (
B
) from
inside of unit. Tighten by hand.
5. Insert “L” bolt (
A
) through hole just below billboard on
right side of handle (viewing from front of unit). Hold
bolt in place and attach plastic knob (
B
) from inside of
unit. Tighten by hand.
Add Engine Oil and Fuel
• Place pressure washer on a level surface.
NOTE:
Verify provided oil bottle is the correct viscosity for
current ambient temperature.
• Refer to engine operator’s manual and follow oil and
fuel recommendations and instructions.
NOTE:
Check oil often during engine break–in. Refer to
engine operator’s manual for recommendations.
7
A
B
C
A
B
A
B
NOTICE
Any attempt to crank or start the engine before it has been
properly filled with the recommended oil will result in
equipment failure.
• Refer to engine manual for oil and fuel fill information.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
