13
14
©2005 Diamond Audio Technology. All Rights Reserved
©2005 Diamond Audio Technology. All Rights Reserved
INPUT
The RCA cables from your source unit should be inserted here.
MASTER OUT
This RCA output is used to provide a master signal to slave amplifiers.
SLAVE IN
This RCA input is used to receive signal from a master amplifier.
RCA
D6 1000.1/1500.1
Both D6 mono block amplifiers come with a remote gain output. The remote gain module
(included) plugs into this output to allow for gain control away from the amplifier. When
you plug this module in, it replaces the gain from where it is set on the amplifier. Max
(all the way clockwise) on the module is set to whatever the gain on the amp is set to.
Note: Old D5 600.11200.1 remote gains do not work with D6 amplifiers.
Remote Gain
Although the D6 1000.1 and 1500.1 amplifiers have two sets of outputs, they are
mono-block amplifiers and the outputs can not be bridged. The two sets of outputs are
paralleled inside the amp to a single channel. This gives you ease during the installation
of multiple voice coils or woofers.
Note: It is important that a 1 Ohm minimum total speaker impedance load is
observed! If an impedance load of less than the above minimums is used, you will
eventually damage your amplifier and void your warranty.
Speaker Outputs
Crossover Freq. Diagrams
Highpass (multiplier)
Lowpass
D6 300.4/600.4
