Set antenna to be raised to 90 degrees by operating the control switch.
Loosen the nut (side of antenna
mount) and set antenna for vertical
position.
Adjust knob by using coin in
coingroove.
• Fasten screws after adjusted.
This product was manufactured under strict quality control,
if damage occurred during shipping, contact your dealer.
Design and specifications of this product are subject to change
without notice.
Power Cord Wiring
• Attach wires from control box and motor drive mount.
A positive voltage is applied on both power cords. If power cords
are forced unreasonably or pinched, the fuse may blow due to the
short.
• Wire the connector of the control box to the connector of the
mount bracket. Insert cigar plug.
* Using fuse greater than 0.5 Amp may cause damage to mount.
• Mount the antenna before making angle adjustment. Turning of
the adjust knob during antenna’s down position may cause dam-
age to the limit switch.
* Operating angle at shipment is set at 45 degrees.
Operating Angle Adjustment
Specifications
Antenna Length to be Installed
45” maximum
Antenna Weight to be Installed
1 lb. maximum
Operating Voltage
13.8 V (10-16 V)
Operating Current
less than 0.4 A
Operating Time
about 4 seconds (0-90°)
Operating Angles
45-90 degrees
Fuse Capacity
0.8 A
0.8A Fuse
located in cigar
plug
→
