Welcome
7
Connecting TDM Signaling and Bearer Ports
The Bearer ports (Interface Offsets) 0-27 are connected to the TDM network. Each
Bearer Port can have signaling and bearer channels configured on it.
The Signaling/Timing Ports are connected to the TDM network, and can also be used
for signaling and bearer traffic the same as the Bearer ports. See the „T1/E1‟ under the
„Configuration‟ section in the online help for more information.
SS7 Signaling links and ISDN D-channels can be brought in over either the
Signal/Timing Ports or the Bearer Ports. See „signaling‟ under the „Configuration‟
section in the Online Documentation for more information.
Starting ClientView to start Configuring Switch
Once the IMG 1010 has software installed, the cabling is connected, and the GCEMS server
has been configured, the ClientView application can be used to configure the system. Below
are a few topics from the Online Documentation to get started on configuring the IMG 1010
through the ClientView GUI.
Configuration > ClientView > (All topics under this book)
Configuration > Introduction
Configuration > Node Configuration Wizard
Configuration > Basic Configuration
From here, the IMG 1010 can be configured for your network. Use the Online Manual
Configuration, Clientview, and ClientView Pane sections to configure the IMG 1010.
