IMG 1010 Quick Start Guide
Connecting and Configuring Network Management Port ‘CTRL 0’
The information below will provide the user with a basic setup sequence for connecting
and configuring the IMG 1010 along with the GCEMS server to download system software
and start configuring the IMG 1010 using the ClientView GUI. On the rear of the IMG 1010
are the network interfaces. The first interface -CTRL 0- is a Fast Ethernet port dedicated
to network management. This port is connected to the GCEMS server and allows the
GCEMS server to access the IMG 1010.
1.
Connect up the cables as shown in the first figure below.
2.
Once the cables are connected, configure FTP and DHCP on the GCEMS server. Locate
the MAC address that is printed on a label located on the underside rear of the IMG
1010. This will be used in the dhcpd.conf file creation.
For more information on how to set up the services refer to the topics under the following
sections in the Online Documentation
•
IMG 1010-Installation and Setup Guide > IMG 1010-Software Installation and Setup
If your setup requires using an SD card to load system software refer to the topics under
the IMG 1010-SD Card heading below in Online Documentation.
•
IMG 1010-Installation and Setup Guide > IMG 1010-SD Card
Dialogic Corporation
Part # 07-8728-04
Page 7 of 9
