Dialog DA16200, Руководство пользователя

Страница: 10 / 20

DA16200 AT GUI Tool
User Manual Revision 1.0 DRAFT 03-Jul-2019
CFR0012 10 of 20 © 2020 Dialog Semiconductor
●
Check TX Setting parameters and click the Mode Select button. Confirm message will be shown
as
Figure 10. This is a normal state
Figure 10: Debug Console - Tx mode
●
Have to select Data Rate, Channel, and Power as you want to test.
○
Packet mode : Normal test mode with packet generation mode. We can adjust duty of RF
Burst at time domain in this mode.
○
Cont mode : Continuous TX out mode.
○
This mode is for TX power test and etc.
○
In this mode, TX packet is generated continuously over 95% duty cycle.
○
CW mode : Only single sinewave tone out mode. This mode is for freq err check.
○
Data Rate : Choose modulation type to test.
○
Power
: Select or tune the power level. (“0” step is Maximum)
○
The difference between power steps is about 0.8~1dB/1step
○
Size : You can adjust duty rate with this number. However, it is not linear as the number, so it
needs to check with equipment like spectrum analyzer to set exactly. (Equipment setting is to
zero span setting or burst mode setting)
●
TX packet generation
○
Use the Start TX button and the Stop TX button.
○
When you want to change for another condition, you should click “Stop TX” before starting
new test.