UM-GP-006
GreenPAK Pro Development Platform
User Manual
Revision 1.1
15-Sep-2021
CFR0012
11 of 33
© 2021 Dialog Semiconductor
Figure 6: Choosing Generators
Logic generator is used for generating logic pulses.
I
2
C generator allows the user to create I
2
C signals based on logic generators. There are two logic
generators combined together as SDA and SCL lines. The user can combine predefined I
2
C settings
to generate a needed waveform and choose SCL frequency.
SCL sends I
2
C-compatible SCL signal to the line. SCL works only in a 'read-only' mode. SCL clock can
be configured by choosing predefined frequency. The set of those frequencies depends on the
development platform.
SDA sends I
2
C-compatible SDA signal to the line. In Signal Wizard special editor shows sequence of
commands. There are some actions in command editor the user can do.
Signal generator is used to generate analog signals: constant voltage level, sine, trapeze (trapezoid),
logic pattern, and user-defined.
There is a possibility to start all the generators using buttons at Debugging controls panel.
Figure 7: Managing Buttons
Note 1
These buttons can be controlled only by generators with installed Global Linkage flag.
Figure 8: Global Linkage Settings
