9
Shutter
064-095
Strobe effect slow to fast
096-127
shutter open
128-159
Pulse-effect in sequences
160-191
shutter open
192-223
Random strobe effect slow to fast
224-255
shutter open
10
Dimmer
0-255
Dimmer 0%...100%
11
Focus
0-255
In(near) to out(far)
12
Prism
0-005
Prism swing out
006-127
Prism swing in
128-189
Forwards rotation from fast to slow
190-193
Prism rotation stop
194-255
Backwards rotation from slow to fast
13
Iris
0-191
Max. diameter to Min.diameter
192-223
Pulse opening fast to slow
224-255
Pulse closing slow to fast
14
Speed
0-255
max to min speed for Pan/Tilt
15
Special
0-019
Color change normal
020-029
Color change to any position
030-039
Color & gobo change to any position
040-079
No function
080-099
Motor reset
100-119
Internal program 1
120-139
Internal program 2
140-159
Internal program 3
160-179
Internal program 4
180-199
Internal program 5
200-219
Internal program 6
220-239
Internal program 7
240-255
Internal program 8
2.
2.
2.
2. S
S
S
Safety
afety
afety
afety IIIInstructions
nstructions
nstructions
nstructions
This device has left the factory in perfect condition. In order to maintain this condition and to ensure a
safe operation, it is absolutely necessary for the user to follow the safety instructions and warning
notes written in this user manual.
If the device has been exposed to temperature changes due to environmental changes, do not switch
it on immediately. The arising condensation could damage the device. Leave the device switched off
until it has reached room temperature.
This device falls under protection-class I. Therefore it is essential that the device be earthed.
The electric connection must carry out by qualified person.
The device shall only be used with rate voltage and frequency.
Make sure that the available voltage is not higher than stated at the end of this manual.
Make sure the power cord is never crimped or damaged by sharp edges. If this would be the case,
replacement of the cable must be done by an authorized dealer.
Always disconnect from the mains, when the device is not in use or before cleaning it. Only handle the
power cord by the plug. Never pull out the plug by tugging the power cord.
During initial start-up some smoke or smell may arise. This is a normal process and does not
necessarily mean that the device is defective, it should decrease gradually.
Please don't project the beam onto combustible substances.
Fixtures cannot be installed on combustible substances, keep more than 50cm distance with wall for
smooth air flow, so there should be no shelter for fans and ventilation for heat radiation.
If the external flexible cable or cord of this luminaire is damaged, it shall be exclusively replaced by the
manufacturer or his service agent or a similar qualified person in order to avoid a hazard.
