BF-410
Floor grinder
Strana 7
2.4.
Mounting and dismounting of tool
!ATTENTION! Always follow the instructions below when mounting or dismounting tool! (Only then you can set
up the machine with tool correctly and safely.) The machine must be always secured against movement and the
motor switched off and unplugged when changing tool!
2.4.1.
Mounting of tool (see Pic.)
1. Remove all additional weights.
2. Make sure that handlebars are securely locked.
3. Tilt the machine over its rear wheels and rest it on the handlebars.
4. Secure machine against tilting back.
5. Do not leave the machine in this position longer then necessary!
6. Abrasives (3) (emery disc, TC disc.) place it on tool (2) and tighten with bolt (4) so, that the screw (A)
protrude maximally 2 mm over the tools nut (B).
Note: Always use the correct diameter of abrasive disc (410 mm).
7. Place the tool (2) on to carrier (1) so, that the slots in the tool correspond with the protrusions on the
carrier. Secure the tool by turning it against the sense of rotation of the motor until it clicks in and after that
tighten the mounting bolt with Allen key (5) so, that can not turn the tool freely.
2.4.2.
Dismounting of tool
Similarly dismount the tool in rear order.
