Diagraph PA/4000, Руководство по обслуживанию, Страница: 56 / 213

PA/4000 User’s Manual
Section 5, Configuration
Page 17
To set the Product Delay value:
1. Start the conveyor.
2. Take the PA/4000 out of pause mode by pressing the PAUSE/RESUME
key on the Hand-Held terminal.
3. From the Menu screen, press the down arrow key three times.
4. The display shows the Product Delay screen.
5. Press the MENU/SELECT key to enter Edit mode (the value will flash).
6. Use the arrow keys to increase or decrease the Product Delay value.
7. Press the MENU/SELECT key to accept the changes. The value entered
will not be used until the MENU/SELECT key is pressed and the
display is no longer flashing.
8. Hold the 2nd key and press the MENU/SELECT key (while the display
is still flashing to CANCEL).
9. Repeat this process until the label is applied where you want it on the
product.
5.4.5 Setting the Position of the Label Present and Auto-Retract Sensors
The tamp pad assemblies for labels 4 inches long and greater will have more
than one location available for mounting the auto-retract sensor. The choice of
which location to use will depend on the direction of the product and whether
the label is being applied to the leading or trailing edge of the product. The
auto-retract sensor should be located in a position that will be towards the
inside of the product so that it can be assured of sensing the product regardless
of any changes in line speed. The bottom of the label present and auto-retract
sensors should initially be set to 0.20 inches from the bottom of the tamp pad. If
necessary the sensors can be moved up or down 0.05 inches to detect certain
labels or products.
REAR PLATE
GASKET
IMPACT PLATE
FOAM
POSITION OF LABEL PRESENT AND
AUTO RETRACT SENSORS
.20” ± .05”