Diagraph PA/4000, Руководство по обслуживанию, Страница: 52 / 213

PA/4000 User’s Manual
Section 5, Configuration
Page 13
mounting plate and adjust the yoke until it is
level and retighten the bolt. Then loosen the
yoke bolts
[E]
holding the main unit and
adjust the main unit until it is level and
retighten the bolts. This will make the tamp
pad completely parallel to the product
surface.
5. For now, move the test product out of the
path of the tamp pad but keep it nearby. With
the tamp pad fully extended, slowly turn the
crank handle on the stand to lower the
PA/4000 until the tamp pad extends about 1
inch past the surface of the product.
6. Manually return the tamp pad to the
cylinder’s fully retracted position and turn
ON the air supply. To begin with, adjust the
tamp air pressure
[F]
to 25 psi (between 20-40
psi is the usual range).
CAUTION: DO NOT PLACE YOUR
HAND BETWEEN THE PA/4000
MAIN UNIT AND THE TAMP PAD.
7. Press PAUSE-RESUME on the Hand-Held to
resume the air cylinder/tamp pad action. This
triggers the cylinder/tamp pad to cycle. Adjust
the psi until the tamp pad appears to extend equal
to the surface of the test product. Replace the test
product back into the path of the tamp pad.
Notice the force the tamp pad extends and
retracts.
8. Press PAUSE-RESUME again to pause the cycling
action. To attain the proper force of the air cylinder/tamp pad extension and
retraction, adjust the top
[B]
and bottom
[C]
air flow controls by turning
clockwise one full turn at a time. Count how many full turns are made to get
the right amount of force necessary considering the product, label size, etc.
Record the turns on the PA/4000 Configuration Sheet (see Section 6). You may
have to readjust the tamp air pressure
[F]
to get the correct amount of air
pressure. When you are satisfied with the psi and air flow settings, go to the
next section on setting the tamp dwell.
!
[F]
[D]
[E]