DiabloSport Predator, Руководство пользователя

Страница: 16 / 36

Modify Tune Procedures
1. When selecting the “Modify tune” function, a disclaimer will
appear. Read and press “Enter” to continue.
2. The “modify Performance Tune menu will appear. You will
have 2 choices:
• Modify Parameters
• Reset all Parameters
3. Highlight the appropriate choice by using the arrow keys &
press “Enter”
4. In the “Modify Parameters” Menu the following choices will
appear for your Hemi applicable vehicle:
• Speed Limiter
• Idle Speed
• WOT Spark Advance
• WOT Fuel Table
• Knock sensor Enable/Disable
• Cooling Fans
• Rev limiter
“Parameters/Features may not apply to all applications and may
not be available upon release. Check www.diablosport.com for
current parameters.
5. Highlight the appropriate choice by using the arrow keys &
press “Enter”
6. Modify the appropriate parameter by using the arrow keys
& press “Enter” to continue. [ These parameters should only be
changed is you have a understanding of tuning. Engine or ECM
damage can occur without proper knowledge.]
7. Verification will display “Are you sure?” press “Enter” to
continue
8. The display “this change will take effect next time you install
the tune” will appear – Press “Continue”
9. Use the “ESC” key to go back through the menus and either
continue to change parameters or go to the “install tune now?”
menu. Press “Enter “ to continue.
10. The tune should now be building. Do not interrupt this
process or PCM damage can occur.
11. Follow the prompts to turn on & off the ignition (do not
start the car at any time) press “enter” if prompted
12. The tune should now be writing. Do not interrupt this pro-
cess or ECM damage can occur.
During programming do not touch any buttons or open and
close doors, the theft light will blink rapidly and on some ve-
hicles the electric fans will come on during programming.
13. Follow the prompts to turn ON & OFF the ignition (do not
start the car at any time) press “Enter” if prompted
14. When the process is complete, the Message “ {xxxxxx} tune is now in
vehicle. You may drive it now. Please unplug the tool” Unplug the preda-
tor from the Diagnostic port. Cycle the key, and start the vehicle. You are
now able to enjoy the force of the Predator!
NOTE If tune is not installed at the prompt the adjusted parameters will
not be lost, they will be saved, just not installed in the vehicle.
To reset parameters, simply press “Reset Parameters” button.
When switching from Performance Tune, Stock tune or Custom tune you
will be prompted to keep or discard adjusted parameters.
Modifing
Parameters
&
Quick Adjust