DLEV1
Operating Instructions
- 8 -
Introduction
The DLEV1 is a handheld, testing adaptor designed to interface
between electric vehicle supply equipment (EVSE) and a multifunctional
electrical installation test instrument capable of performing a
comprehensive range of tests.
The DLEV1 will enable the user to safely conduct the following
measurements when used in conjunction with a multifunctional electrical
installation tester:
•
PE Pre-Test to indicate the potential presence of dangerous
voltage at the PE terminal before testing commences via a
touch electrode and led indicator.
•
Live phase to neutral presence of all phase voltages indicated
by three individual phase led indicators.
•
PP State simulation (Proximity Pilot) simulating the current
capabilities of the charging cable; NC, 13A, 20A, 32A and 63A
with a rotary switch.
•
CP State simulation (Control Pilot) simulating various vehicle
charge states, A, B, C & D with a rotary switch.
•
CP Error
“E” simulation where the signal is short-circuited to PE
via a push button.
•
PE Error simulates an earth fault interrupting the PE conductor
via a push button.
•
4mm input terminals for test leads to connect to multifunctional
electrical installation testers; L1, L2, L3, N and PE conductors
(figure 3).
•
CP Signal Output via two 4mm terminals for connection to an
oscilloscope to check waveform and amplitude of the CP signal.
•
13A mains socket for multifunctional installation tester
connection or external loading up to 10A (figure 2).
The adaptor is designed to test the function and electrical safety of
charging stations mode 3 for AC charging.
With this adaptor, charging stations can be tested in accordance with
IEC/EN62851-1 and IEC/HD 60364-7-722.
Please read this instruction manual carefully to ensure the safe
performance and function of the test adaptor.