Dhollandia DH-S Series, Руководство по установке

Страница: 20 / 82

19
DHOLLANDIA
7 TYPES OF CHASSIS AND FITTING METHODS
•
Most slider liftgates are equipped with bolt-on sliding tubes (except
for the DH-SP and DH-SV which come with weld-on sliding tubes),
adapted to the type of chassis of the vehicle.
•
The distinction between “side - mounting” and “under - mounting” can
be made by whether the tubes are being attached to a truck chassis,
or a trailer or semi-trailer chassis, respectively.
•
1 in Figure 7.3 shows the tubes side-mounting to a truck chassis. 2
in Figure 7.3 illustrates under-mounting aluminium tubes to a trailer
chassis. Finally, 3 in Figure 7.3 shows under-mounting steel tubes to
a trailer chassis.
•
The slider liftgates covered by this manual are all actuated in / out by
means of a hydraulic motor [see Figure 7.1
– 7.2].
•
The hydraulic motor does not require any fixation of the drive system
to the vehicle chassis. In comparison to a double acting retraction
cylinder, this motor allows:
1. To reduce fitting time
2. To reduce the required overhang
dimension
•
The DH-S* liftgate range with a 1500-3000 kg capacity is comprised
of 2 generic frame types and slide plates:
1. Bolt-on slide plates, which can be moved side to side to
adjust their position to the width of the vehicle chassis.
[Figure 7.4]
2. Pre-mounted or integrated slide plates, which cannot
move side to side, but are configurable via their adjustable
mounting brackets. [Figure 7.5]
•
Take this information into account when preparing the fitting work
of the liftgate.
Figure 7.1
Figure 7.2
Figure 7.3
Figure 7.4
Figure 7.5
❶
❷
❸