AMH-38™ AND AMH-100™ OPERATION AND MAINTENANCE MANUAL
To install the AMH mass set, follow the order of operation below carefully (refer to Figure 7):
Prepare the masses:
Open the shipping cases and remove all the masses and mass set elements
from their plastic bags.
Install a piston-cylinder module in the PG7000 Platform:
See the PG7000 Operation and
Maintenance Manual, Installing a Piston-Cylinder Module Into the Platform.
Install the binary mass carrier:
Place the pyramidal shaped carrier on top of the piston cap.
Install the mass loading bell:
Slip the mass loading bell over the binary mass carrier and slide it
down until the inside top of the bell sits on the binary mass carrier.
Install the main mass discs:
Load the main mass discs (6.2 kg each with AMH-38, 10 kg each with
AMH-100) onto the mass bell
starting with mass #1 and loading in sequential order
. Mass #1
should be at the bottom of the stack and the highest number mass at the top. The mass sequence
numbers are lazer marked on the top surface of each mass. Pass the mass disc over and down the
mass loading bell and center it on the ledge at the bottom of the bell. Load the rest of the main
masses, sequentially, onto the bottom mass.
Install the binary mass tubes:
Load the binary mass tubes concentrically from the largest to
smallest, outside to inside. The largest, long tubes slip down between the main mass stack and the
bell and rest on the ledge at the bottom of the mass bell. The smaller masses load onto the
pyramidal steps of the binary mass carrier.
The mass loading process is complete:
The mass set is in the all loaded position. The mass lifting
shaft/trim mass tray assembly is not yet installed. It will be attached after the AMH autmomated
mass handler is installed over the masses on the platform.
Create the mass set and mass loading bell in the PG Terminal:
See the PG7000 Operation and
Maintenance Manual, Add Mass Set and Add Mass Loading Bell Sections.
SHOWN IS THE MS-AMH-38 MASS SET FOR THE AMH-38 MASS HANDLER. SMALLER MASS SETS MAY INCLUDE LESS
MAIN MASS DISCS. MASS SETS FOR THE AMH-100 MASS SET ARE IDENTICAL TO AMH-38 BUT THE MAIN MASSES
ARE LARGER 10 KG DISCS AND A 7TH BINARY MASS TUBE OF 6.2 KG IS INCLUDED.
Figure 7
. AMH Mass Set
© 2007 DH Instruments, a Fluke Company
Page 16
