2
Hardware Installation
35
Front Audio
The front audio connector (J1) allows you to connect to the
line-out and mic-in jacks that are at the front panel of your sys-
tem. Using this connector will disable the rear audio’s line-out
and mic-in functions.
Remove the jumper caps from pins 5-6 and pins 9-10 of J1 prior
to connecting the front audio cable connector. Make sure pin 1
of the cable connector is aligned with pin 1 of J1. If you are not
using this connector, make sure to replace the jumper caps back
to their original pin locations.
The front audio is disabled.
The rear audio is enabled.
The front audio is enabled.
The rear audio is disabled.
Pins 5-6 and 9-10 short
(default)
Pins 5-6 and 9-10 open
Driver Installation
Install the “Audio Drivers”. The audio application utility will at the
same time be installed into the system. The utility will allow you
to configure the rear audio jacks to 6-channel audio modes as
well as configure its audio effects. When the rear audio supports
6-channel, the mic-in jack will be disabled. Use the front audio’s
mic-in function. Refer to chapter 4 for more information.
