2
36
Hardware Installation
4-Channel Audio
The 4-channel connector (J27) suppor ts four audio output signals:
center channel, subwoofer, rear right channel and rear left chan-
nel. The 4 audio output signals together with the line-out jack (at
the rear panel) suppor t 6-channel audio output.
One card-edge bracket, mounted with a rear jack and a center/
subwoofer jack, will be provided as an option. Remove the
jumper caps from pins 2-4 and pins 6-8 of J27 prior to connect-
ing the audio cable connector. Make sure pin 1 of the cable con-
nector is aligned with pin 1 of J27. If you are not using this con-
nector, replace the jumper caps back to their original pin loca-
tions. Now install the card-edge bracket to the system chassis.
Driver Installation
Install the “Audio Drivers”. An audio software application pro-
gram will at the same time be installed into your system. This
program will allow you to configure 2-channel, 4-channel and 6-
channel audio modes as well as configure the audio effects. Refer
to chapter 4 for more information.
