40
Choosing “Enabled” in the Power Management option will allow you to
set Doze Mode, Standby Mode and Suspend Mode. Choose “Disabled”
if you do not want your system to enter the power saving mode.
PCI Configuration Setup
Use the arrow keys to highlight “PCI Configuration Setup” and press
<Enter>; a screen similar to the one below will appear.
The G586IPB/E system board supports four PCI slots. Each slot may be
assigned INT A, B, C, D if the card installed in the slot requires an
interrupt. Each INT may then be assigned an IRQ value. This is done
automatically if the “PnP BIOS Auto-Config” option is enabled.
Load BIOS Defaults
The “Load BIOS Defaults” option loads the troubleshooting default val-
ues permanently stored in the ROM chips. These settings are non-opti-
mal and turn off all high performance features. You should use these
values only if you have hardware problems. Highlight this option in the
main screen and press <Enter>. The message below will appear.
Load Setup Defaults (Y/N) ? N
If you want to proceed, press <Y> and the default settings will be
loaded.
