DFI Blood-Iron P43-T34, Руководство пользователя

Страница: 23 / 118

23
English
E
English
The power connectors from the power supply unit are designed to fi t the 24-pin
and 8-pin connectors in only one orientation. Make sure to fi nd the proper orien-
tation before plugging the connectors.
The system board requires a minimum of 300 Watt power supply to operate. Your
system con
fi guration (CPU power, amount of memory, add-in cards, peripherals,
etc.) may exceed the minimum power requirement. To ensure that adequate
power is provided, we strongly recommend that you use a minimum of 400 Watt
(or greater) power supply.
Important:
Insuf fi cient power supplied to the system may result in instability or
the add-in boards and peripherals not functioning properly. Calculating
the system’s approximate power usage is important to ensure that the
power supply meets the system’s consumption requirements.
Restarting the PC
Normally, you can power-off the PC by:
1. Pressing the power button at the front panel of the chassis.
or
2. Pressing the power switch that is on the system board (note: not all system
boards come with this switch).
If for some reasons you need to totally cut off the power supplied to the PC,
switch off the power supply or unplug the power cord. Take note though that if
you intend to restart it at once, please strictly follow the steps below.
1. The time where power is totally discharged varies among power supplies. It’s
discharge time is highly dependent on the system’s con fi guration such as the
wattage of the power supply, the sequence of the supplied power as well as
the number of peripheral devices connected to the system. Due to this rea-
son, we strongly recommend that you wait for the Standby Power LED (refer
to the “LEDs” section in this chapter for the location of the Standby Power
LED) to lit off.
2. After the Standby Power LED has lit off, wait for 6 seconds before powering
on the PC.
If the system board is already enclosed in a chassis which apparently will not
make the Standby Power LED visible, wait for 15 seconds before you restore
power connections. 15 seconds is approximately the time that will take the
LED to lit off and the time needed before restoring power.
The above will ensure protection and prevent damage to the motherboard and
components.