DFI 586ITB, Руководство пользователя

Страница: 49 / 73

49
Reset Configuration Data
Enabled
Disabled
The BIOS will reset the configuration data once automatically.
The BIOS will not reset the configuration data.
PCI IDE IRQ Map To
This category is used to configure your system to the type of IDE disk
controller in use.
ISA
PCI-Auto
Designates which ISA slot is installed with an IDE controller
card; that is, if you are using an IDE controller card.
The system will scan and determine the PCI slot that is in-
stalled with an IDE controller card.
Primary IDE INT# and Secondary IDE INT#
The Primary and Secondary IDE INT# categories are used to select the
PCI interrupt (A, B, C, or D) that is associated with the connected hard
drives.
Assign IRQ for VGA
If Enabled, the system will automatically set an IRQ for the VGA card
installed. Your VGA card will need an IRQ address only when using the
video capture function of the card. If you are not using this function and
a new device requires an IRQ address, you can set this function to
Disabled. The IRQ address (previously occupied by the VGA card) will
be available for your new device.
Load Fail-Safe Settings
The “Load Fail-Safe Settings” option loads the troubleshooting default
values permanently stored in the ROM chips. These settings are not
optimal and turn off all high performance features. You should use
these values only if you have hardware problems. Highlight this option
on the main menu and press <Enter>. The message below will appear.