Dexter Power NC1300CS, Руководство пользователя, Страница: 24 / 28

Dexter Power
24
EN
Original Instructions
WARNING! Never use the product if the lower guard is not operating properly. Carefully check the lower guard before each
use. If the lower guard does not close or moves freely, have it checked and repaired by a qualified specialist before using this
product.
WARNING! Never use the product for a plunge cut.
Mark the line of cut on the work piece.
Adjust the depth of cut and bevel angle as required.
When making 90° cross , align your line of cut with the outer blade guide notch on the base of the saw(0). When making 45° bevel
cuts, align your line of cut with the inner blade guide notch on the base of the saw(45).
Rest the front edge of the base on the workpiece. Make sure the power cord is out of the way of saw the blade and not in the line
of cut. Start the motor by depressing the lock-off button and squeezing the trigger switch.
NOTE : Always let the blade reach full speed before you begin to cut into the workpiece.
Slowly push the saw forward using both hands. Apply downward pressure to keep the saw steady and only enough forward
pressure to keep the blade cutting.
When making a cut always use steady, even pressure. Forcing the saw causes rough cuts and could shorten the life of the saw
or cause kickback. Allow the blade and the saw to do the work.
After completing your cut, release the trigger switch and allow the blade to come to a complete stop. Do not remove the saw from
the workpiece while the blade is moving.
NOTE : Since blade thickness varies, always make a trial cut in scrap material along the guideline to determine how much, if any,
the guideline must be offset to get an accurate cut.
WARNING : Keep all parts of your body away from the blade after operated, the blade will be very hot.
NOTE:
Vacuum cleaner must be connected before cutting.
Using the laser
Fig. 9
WARNING. Before proceeding to use the laser line system, ensure that the Safety Rules for Laser Lights section is read
and fully understood. Always ensure the laser beam is aimed at a sturdy workpiece without reflective surfaces .i.e. wood or rough
coated surfaces are acceptable.
Bright shiny reflective sheet steel or the like is not suitable for laser use as the reflective surface could direct the beam back at
the operator.
Only turn the laser beam on when the tool is on the workpiece.
Mark the line of the cut on the pieceworker.
Adjust the depth of cut and bevel angle as required.
Rest the front edge of the base on the pieceworker.
Switch on the laser beam by pushing the laser switch forward.
Align the beam with the line on the pieceworker.
Start the motor by depressing the lock-off button and squeezing the trigger switch
.Always let the blade reach full speed before you begin to cut into the work piece.
Slowly push the saw forward using both hands, keeping the red laser light beam on the line of cut.
After completing your cut, release the trigger switch and allow the blade to come to a complete stop. Do not remove the saw from
the pieceworker while the blade is moving.
Switch off the laser beam by pushing the laser switch backward on completion of the cut.