Dexter Power NC1300CS, Руководство пользователя, Страница: 23 / 28

Dexter Power
23
EN
Original Instructions
Fixation and changing the blade
Fig. 7
NOTE:
The blade is not installed on the tool during shipment
WARNING: Do not use any abrasive wheels! Always use the correct saw blades according to the intended use! Always
ensure that the saw is switched off and unplugged from the power source before making any adjustments.
WARNING: only use the blade diameter(s) in accordance with the marking.
WARNING: Always wear sturdy gloves when handling or changing blades as they can be very sharp.
Only use sharp and undamaged saw blades. Cracked or distorted saw blades must be replaced immediately. Place the saw on
its side on a flat surface.
Fixation the blade
Press down the spindle button and loosen the outer flange along the counter-clockwise direction by using the wrench provided.
Remove the blade bolt and the outer blade flange.
Raise the lower blade guard using the blade guard lever.
Fix the saw blade into the output shaft and make the blade fit to the inner flange.
Put back the outer flange and blade bolt, tighten the bolt by using the wrench provided.
Changing the blade
Press down the spindle button and loosen the outer flange along the counter-clockwise direction by using the wrench provided.
Remove the outer blade flange and the blade bolt.
Raise the lower blade guard using the blade guard lever. Remove the saw blade from the inner flange and pull it out.
Clean the saw blade flanges thoroughly before mounting the new saw blade. Wipe a drop of oil onto the inner and outer flange
where they will touch the blade.
Mount the new saw blade onto the spindle and against the inner flange. Replace the outer flange and tighten the blade bolt.
WARNING: The direction in which the blade rotates has to be the same as the direction of the arrow marked on the housing.
Before using the saw again, check that the safety devices are in good working order.
IMPORTANT. After fixing or replacing the saw blade, make sure that the saw blade runs freely by turning the blade by hand.
Plug the machine into a power socket and run the saw under no load to check that it runs smoothly before using it to cut any
material.
4. USE
Switching on and off
Fig.8
The tool is equipped with a lock-off button which can be pushed to left or right direction for your left or right hand operation easily
and this can avoid unintentional starting.
To switch on, depress the lock-off button and squeeze the trigger switch. To switch off, release the trigger switch.
CAUTION: Allow the blade to come to a complete standstill before setting the saw down.
Making a cut
WARNING: The saw blades shipped with this product are for cutting wood. Do not attempt to saw stone and ceramic tile
materials with these saw blades. Before operation, ensure that the saw blades are free from damage and properly fitted to the
product
.