Dexter Power 3 276000 620624, Сборка, использование, руководство по обслуживанию

Страница: 81 / 180

4. TECHNICAL DATA
Type designation NC900BS.1 Belt Sander
Rated voltage 230V~ 50Hz
Rated power input 900W
Speed, n
0
120-380m/min
Sanding belt size 76 x 533mm
Level of acoustic pressure L
pA
(K
pA
=3dB(A)) 92.3 dB(A)
Level of acoustic power L
wA
(K
wA
=3dB(A)) 103.3 dB(A)
Level of vibration a
h
(K=1.5m/s 2 ) 10.6 m/s 2
NOTE:
- the declared vibration total value has been measured in accordance with a standard test method
and may be used for comparing one tool with another;
- the declared vibration total value may also be used in a preliminary assessment of exposure.
WARNING:
- the vibration emission during actual use of the power tool can differ from the declared total
value depending on the ways in which the tool is used;
- avoid vibration risk such as: maintain the tool and the accessories, wear gloves during operation,
limit operating time and shorten trigger time.
Contents of packing
1 Belt sander with sanding belt (80 Grain)
1 Dust bag
1 Instruction manual (with 1 safety instructions and 1 guarantee card)
After unpacking, check the tool and accessories for damages and do not use the tool in case something is defective.
5. BEFORE PUTTING THE EQUIPMENT INTO OPERATION
Selecting the right grade of sanding belt
Different grades of sanding belt can be purchased from the store where you purchased the tool. Available grades are: Coarse, Medium and Fine.
Use a coarse grit to sand down rough finishes, medium grit to smooth the work and fine grit to finish off.
It is best to make a trial run on a scrap piece of material to determine the optimum grades of sanding belt for a particular job.
69
EN