Dexter Laundry Wn0600ea-13en2x-sskcs-usx, Руководство по запчастям и обслуживанию

Страница: 135 / 159

Part # 8533-097-001 11/16
135
To Install:
1) Remove electrical power from the machine.
2) Remove top panel, rear panel, and lower service door.
3) Remove the 2" pipe plugs from the couplings in the tub back (Fig. 1) and the sump (Fig. 2).
4) Using Teflon tape on the threads, screw the reducer bushing into the coupling at the bottom of
the tub back. (Fig. 3)
5) Seal the temperature sensor threads with Teflon tape and install into the reducer bushing. (Fig. 3)
6) Plug in one end of the sensor wiring harness to the temperature sensor. (Fig. 3)
7) In the control box, remove the I/O board cover and plug the temperature control board into the
appropriate socket in the I/O board. Attach the temperature control board to the standoffs in the
I/O board with the three screws provided. (Fig. 4)
8) Replace the I/O board cover and attach the remaining end of the temperature sensor wiring har
ness into the temperature control board socket. Route the harness away from all moving parts
and wire tie as needed. (Fig. 4)
9) Seal threads of steam baffle assembly with Teflon tape and install it into the coupling on the side
of the sump. Align the holes in the baffle to run from the front to the rear of the sump. (Fig. 5)
10) Unscrew the worm clamp provided and place it around the body of the steam valve just
below the steam valve solenoid housing. Reattach the clamp ends and attach the steam valve
to the steam valve bracket by sliding the worm clamp over the notches in the bracket and tight
ening the worm clamp screw. (Fig. 6)
11) Seal threads of steam hose ends and attach the end without the union to the outlet side of the
steam valve. (Fig. 6)
12) Attach the steam valve bracket to the side panel flange at the rear of the washer, just below the
rear channel with the #10 sheet metal screws provided. (Fig. 6)
13) Screw the coupling end of the steam hose into the threaded end of the steam baffle. (Fig. 7)
14) Attach the green ground wire from the steam valve solenoid to the ground lug in the wiring
connection area at the rear of the machine.
15) Attach one control lead of the steam valve solenoid to the common connection of the soap
injection terminal block.
16) Disconnect the wht/blu signal wire from the cold-flush water valve solenoid (output #6 on the
I/O board) and connect it to the remaining control lead for the steam valve solenoid.
(NOTE: cold water flush to soap box in final rinse is eliminated)
17.Attach user-supplied steam pipe to the inlet side of the steam valve.
(NOTE: manual shut off valve and union coupling connection recommended for easier servicing)
18. Cut relief notch for steam pipe in corner of back panel before replacing.