4
Part # 8533-073-001 11/11
To change the washer cycle, push the Hot temperature button once. The display will change to “C 1”,
indicating cycle one is selected. The temperature buttons are used to make changes to the program. In
the program mode, these buttons will do as displayed in drawing below.
When the display shows “C 1”, push Enter. The display will show “b “ and the PreWash mode light will
blink. Use the Up/Down buttons to move to the bath that will be changed. As Up/Down buttons are
pushed, the next bath mode light turns on.
When the Up button is pushed, the lit bath mode changes from Prewash to Wash. With each additional
push of the Up button, the lit bath mode changes from left to right: Prewash, Wash, Rinse and Final Rinse.
As there are two possible Rinse bathes, for Rinse 1 the Rinse LED and the display changes to “b” in the
left digit and “r1” in the two right hand digits. For Rinse2, the display changes to “b” in the left digit and
“r2” in the two right hand digits. Note that the Spin light is not used. When the Down button is pushed,
the lit bath mode changes from Prewash to Final Rinse, etc.. There is a wrap around feature on the display
in both directions.When the desired bath mode light is on, push Start.
Bath Cycle Time
The selected bath LED begins to blink. The display shows the letters “ct” in the left two digits and the
bath cycle time in the right two digits. Again the up/down buttons change this value. The range is shown
below. If zero time is entered, then the bath will be skipped and the program will return to the bath
selection. When the desired cycle time is selected, push Start.
Bath Water Temperature
The display shows the letter “t” in the left digit and the letters “CC” appear in the right two digits. This is
the bath water temperature. The selection choices are shown below but for the coin washer the value is
defaulted to CC. As it is not selectable with a coin washer, the owner pushes Start to continue.
Bath Water Level
The display shows the letter “L” in the left digit and the letters “LO” appear in the right two digits. This is
the bath water level. The selection choices are shown below but for the coin washer the value is defaulted
to LO. As it is not selectable with a coin washer, the owner pushes Start to continue.
Bath Delay Fill
The display shows the letters “dF” in the left two digits and the letter “t” appears in the right digit. This
is the bath delay fi ll. The selections are “t” for decrementing bath time during the fi ll or “d” for delay the
bath time until water level is reached. When the desired selection is made, push Start.
Bath Spin
The display shows the letter “S” in the left digit and the bath spin time in the right two digits. Again the
up/down buttons change this value. The range is shown below. When the desired spin time is selected,
push Start. The display shows the letters “IS” in the left two digits and the injection selection appears in
the right digit. For the coin washer the default value is “0” and cannot be changed. Push COLD.
The display will show “b” and the bath LED lights will stop blinking. Again use the up/down buttons change
the bath selection. To exit the programming mode, push and hold COLD until price is displayed. The cycle
will be stored when exiting the programming mode.
