3
Part # 8533-073-001 11/11
#4 Warm Water Price:
The next step in the pricing program is to set the additional price for Warm
water usage. The display will blink fi rst “CH P” indicating cold/hot water mix price and then “00.00”.
To change the value, use the Hot temperature button to decrease and the Warm temperature button
to increase. The value will change in 1¢ steps. The range of values is from $00.00 to $99.99.
NOTE:
To not use this feature, set the price to “00.00”.
When the desired price is displayed, push the Start button once to store the new value and a second
time to move to the next Coin/Price programming step. To exit the Coin/Price programming mode,
push the Cold temperature button for 5 seconds.
#5 Hot Water Price:
The next step in the pricing program is to set the additional price for Hot water
usage. The display will blink fi rst “H P” indicating hot water price and then “00.00”. To change the
value, use the Hot temperature button to decrease and the Warm temperature button to increase.
The value will change in 1¢ steps. The range of values is from $00.00 to $99.99.
NOTE:
To not use this feature, set the price to “00.00”.
When the desired price is displayed, push the Start button once to store the new value and a second
time to move to the next Coin/Price programming step. To exit the Coin/Price programming mode,
push the Cold temperature button for 5 seconds. The Coin/Price programming mode will automatically
exit and return to the Idle mode if no buttons are pushed for one minute.
#6 Plus Cycle Price:
The next step in the programming sequence is the Plus Cycle feature. The Plus
Cycle adds three (3) minutes of wash time to the wash bath only. The controller can be programmed
to charge a fee for this or the feature can be turned off. The default setting is off ($0.00).
The display will blink fi rst a “PC P” indicating Plus Cycle price and then price (back and forth). To
change the value, use the Hot temperature button to decrease and the Warm temperature button to
increase. The value will change in 1¢ steps. The range of values is from $00.01 to $99.99. When the
desired price is displayed, push the Start button once to store the new value and a second time to
move to the next Coin/Price programming step. To exit the Coin/Price programming mode, push the
Cold temperature button for 5 seconds.
#7 Decimal Point:
The next step in the programming sequence is the Decimal Point. The display will
blink“dP” and Default value is ON. The value “on” for enable or “off” for disable. Once a pushbutton
is pressed, the display will stop blinking and show the decimal point value. The decimal point value
will display and change with the Hot and Warm buttons. When desired value is reached press Start
button.
Wash Cycle Programming
To change a feature of the wash cycle, push and hold the Hot temperature button and then push the
programming pushbutton on the controller. The Washer mush be in the Idle mode to enter the Wash Cycle
Programming mode. When entering the cycle programming mode the Bleach LED will start to blink and
continue to blink as long as you are in the Cycle Programming mode. The display will show “C 0”. This is
the default cycle number.
NOTE:
The washer can be returned to the factory default settings by holding the right Warm button
and then pressing the left Warm button. The display must show “C 0” to do this. When the cycle
default values are loaded, the washer will automatically exit the programming mode.
NOTE:
The Wash Cycle programming mode will automatically exit and return to the Idle mode if no
buttons are pushed for one minute.
