3
GB/IE/CY
Danger!
It is possible that when the light controller is used the distance to com-
bustible materials such as a lamp shade etc. will be reduced. Please ensure that
there is sufficient safety clearance!
If the lamp shade is closed the maximum power of the bulb must be 60 W!
Open lamp shade
Closed lamp shade
Please also note the instructions of the lamp manufacturer.
Operation
After installation of the light controller you can turn the light on and off as before.
Activation of the Dusk to Dawn Switch Function
j
Turn the light on and off and then on again quickly: The light flashes once briefly
as confirmation.
j
The dusk to dawn switch function is now activated.
After it has become dark outside and the automatic program delay of approximately
2 minutes has expired, the light controller automatically turns the light on. At daybreak
the light goes off automatically with a delay of up to 45 minutes.
When the light is switched on it is turned off automatically for about 1 second approxi-
mately every 45 minutes in order to check the surrounding brightness.
j
The twilight switch function remains on until deactivation, i.e. the light is switched
on every night.
Activation of the Random Switch Function
j
Turn the light on and off and then on again immediately. The light flashes once
briefly as confirmation.
j
Turn the light off again and then on again. The light flashes twice briefly as confir-
mation.
j
The random switch function is now activated.
When it becomes dark and the automatic program delay of approximately 2 minutes
has expired, the random switch function is active. At dawn the random switch function
is halted automatically with a delay of up to 45 minutes.
j
The random switch function remains on until deactivation, i.e. the light is switched
on and off at random intervals every night.
Deactivation of the Dusk to Dawn Switch Funktion / Random Switch
Function
j
Turn the light off for at least 10 seconds.
j
The function is now deactivated.
Troubleshooting
Fault
Cause
Correction
There is no confirma-
tion, the set function
does not work pro-
perly or not at all.
The desired func-
tion has not been
activated properly.
- Turn the light off.
- Wait at least 10 seconds.
- Turn on the desired function as
described under „Operation“.
Cleaning
Please ensure the following before cleaning
j
First of all, turn off the power supply.
j
Then remove the bulb
5
from the socket
4
.
j
Now remove the light controller
3
from the lamp socket
1
.
AV4583_Zufallsschalter_Content_LB6.indd 3
07.05.2008 14:29:37 Uhr
