DeWalt XR Li-ION DCN690-XE, Инструкция по эксплуатации

Страница: 20 / 28

18
FIG. 17 FIG. 18
cc
gg
dd
ee
ff
hh
ee
cc
8. Slide the return system (bb) back into the unit. It is important to try the alignment
of the profile and the flywheel before screwing the return system back on to
the unit. This can be done by connecting a battery and pushing then releasing
the nose of the unit against a bench or hard surface. This will start the motor
spinning.
NOTE:
When the profile and the flywheel are correctly aligned, you will hear
the motor coast back down from full speed. If the profile and the flywheel are not
correctly aligned, the motor it may not start up, may slow down much faster than
normal along with a loud grinding noise from the unit. If this happens remove and
reseat the return system.
9. Once the return system is correctly seated, open the provided sachet of Loctite
®
*
and apply a small amount on the thread of the two screws (aa) and remount the
two screws using the key and tighten securely.
FIG. 19
FIG. 20
aa
WARNING: Always test the unit by firing short nails in to soft wood, to ensure that
the tool is working properly. If tool does not operate properly, contact a recognized
DeWALT service center immediately.
WARNING: Loctite
®
sachet contents may irritate eyes, skin, and respiratory
syetem. Use entire contents on opening.
Do not breath fumes. Do not get in eyes or on skin or clothing. Use only in a well
ventilated area. Keep out of reach of children. FIRST AID TREATMENT: Contains
polyglycol dimethacrylate, polyglycol oleate, propylene glycol, titanium dioxide,