DeWalt XR Li-ION DCN690-XE, Инструкция по эксплуатации

Страница: 13 / 28

11
INTENDED USE
The D
E
WALT cordless framing nailer has been designed for driving nails into wooden
workpieces.
DO NOT use under wet conditions or in presence of flammable liquids or gases.
This cordless nailer is a professional power tool. DO NOT let children come into
contact with the tool. Supervision is required when inexperienced operators use this
tool.
OPERATION
WARNING: To reduce the risk of serious personal injury, lock tool off and
disconnect tool from power source before making any adjustments or removing/
installing attachments or accessories. An accidental start-up can cause injury.
WARNING: Read the section titled Nailer Safety Warnings at the beginning of this
manual. Always wear eye and ear protection when operating this tool. Keep the nailer
pointed away from yourself and others. For safe operation, complete the following
procedures and checks before each use of the nailer.
WARNING: Always observe the safety instructions and applicable regulations.
There may be local workplace regulations applicable which interdict the use of the
bump action mode for certain applications.
1. Wear proper eye, hearing and respiratory protection.
2. Remove battery pack from tool.
3. Lock the pusher in the back position and remove all nail strips from the
magazine.
4. Check for smooth and proper operation of contact trip and pusher assemblies.
Do not use tool if either assembly is not functioning properly. NEVER use a tool
that has the contact trip restrained in the UP position.
5. Never use a tool that has damaged parts.
Installing and Removing the Battery Pack (Fig. 3)
NOTE: For best results, make sure your battery pack is fully charged.
To install the battery pack (L) into the tool handle, align the battery pack with the
rails inside the tool’s handle and slide it into the handle until the battery pack is firmly
seated in the tool and ensure that it does not disengage.
To remove the battery pack from the tool, press the
FIG. 3
FIG. 4
L
P
N
release button (P) and firmly pull the battery pack
out of the tool handle. Insert it into the charger as
described in the charger section of this manual.
Fuel Gauge Battery Packs (Fig. 4)
Some D
E
WALT battery packs include a fuel gauge
which consists of three green LED lights that
indicate the level of charge remaining in the battery
pack.
To actuate the fuel gauge, press and hold the
fuel gauge button (N). A combination of the three
green LED lights will illuminate designating the
level of charge left. When the level of charge in the
battery is below the usable limit, the fuel gauge
will not illuminate and the battery will need to be
recharged.
NOTE: The fuel gauge is only an indication of the
charge left on the battery pack. It does not indicate
tool functionality and is subject to variation based
on product components, temperature and end-user
application.
NOTICE: Do not store tool with battery pack installed. To prevent damage to the pack
and to ensure best battery life, store battery packs out of the tool or charger in a cool,
dry location.
For more information regarding fuel gauge battery packs, please call 1800 444 224
(Aust) or 0800 339 258 (NZ).
Mode Selection
(DCN690 AND DCN692 ONLY)
WARNING: Always wear proper eye [AS/NZS1337] and AS/NZS1270 hearing
protection when operating tool.
The D
E
WALT cordless nailers are assembled in accordance with the ANSI Standard
SNT-101-2002.