DeWalt SDS Plus D25013, Инструкция по эксплуатации

Страница: 8 / 36

6
English
Trigger Switch (Fig. 1)
To start the rotary hammer, depress the trigger switch (A). To stop
rotary hammer, release the switch.
NOTE: Use lower speeds for starting holes without a centerpunch,
drilling in metal, plastics or ceramics, or driving screws. Higher
speeds are better for drilling in masonry for maximum efficiency.
VARIABLE SPEED
The variable speed trigger switch (A) permits speed control. The
farther the trigger switch is depressed, the higher the speed of the
drill.
LOCK-ON BUTTON
WARNING: Be sure to release the locking mechanism before
disconnecting the plug from the power supply. Failure to do so will
cause the hammerdrill to start immediately the next time it is
plugged in. Damage or personal injury could result.
The lock-on button (I) is for use only when the rotary hammer
is stationary, mounted in a drill press stand or for chipping
applications.
Before using the tool each time, be sure that the lock-on button
release mechanism is working freely.
For continuous operation, press and hold the trigger switch (A);
press the lock-on button (I); release the trigger switch and then
release the lock-on button. The tool will continue to run.
To stop the tool in continuous operation, quickly press and release
the trigger switch.
Reversing Lever (Fig. 1)
The reversing lever (H) is used to reverse the rotary hammer for
backing out fasteners or jammed bits in drill-only mode.
CAUTION: When reversing to clear jammed bits, be ready for
strong reactive torque.
To reverse the rotary hammer, turn it off and align the reversing
lever (H) with the yellow arrow pointing backward (viewed when
holding drill in operating position).
To position the lever for forward operation, turn the rotary hammer
off and align the reversing lever (H) with the yellow arrow pointing
forward (viewed when holding drill in operating position).
Mode Selector (Fig. 2)
NOTICE: Tool must come to a complete stop before activating the
mode selector button or damage to the tool may result.
FIG. 2
DRILL-ONLY MODE
F
G
HAMMER/DRILL MODE
F
G
HAMMER-ONLY MODE
G
F