7
1. Dump out debris.
2. Wash tank thoroughly with warm water
and mild soap.
3. Wipe out with dry cloth.
WARNING:
To reduce the risk of injury from accidental
starting, unplug power cord before changing
or cleaning the filter. The filter should be
cleaned often to maintain peak vac performance.
WARNING:
Do not remove filter cage and float. The
float prevents water from entering the impeller
and damaging the motor. The cage prevents
fingers from touching the moving impeller.
CLEANING:
To keep the wet/ dry vac looking its best,
clean the outside with a cloth dampened
with warm water and mild soap.
To clean the tank:
STORAGE:
Before storing the vac,the dust tank should
be emptied and cleaned. The cord should
be wrapped and hung on the unit and the
accessories should be kept in mesh bag
so they can be readily available. The vac
should be stored indoors.
IMPORTANT:
To avoid damage to the blower wheel and
motor, always reinstall the Clean Connect™
filter before using the vac for dry pickups
and wet pickups.
IMPORTANT:
After cleaning, check the filter for tears or
small holes. Do not use a filter with holes
or tears in it. Even a small hole can cause
a lot of dust to come out of the vac.
Replace it immediately.
NOTICE:
Before installing the filter on the vac, clean
the area of the lid so that the filter will seal
against the lid and stop small particles from
bypassing the filter bag. If the filter is clean
and not damaged, replace it on the filter
cage. If it cannot be reused, place a new
filter over the filter cage.
NOTICE:
Clean the filter in an open area. Cleaning
should be done outdoors and not in
living quarters.
CARE AND MAINTENANCE
FILTER REPLACEMENT
Minor problems often can be fixed without calling
customer service.
TROUBLESHOOTING
PROBLEM
SOLUTION
Motor does not run
Check power cord, plugs and outlet.
Ensure the on/ off switch is in the
ON position ( I )
Remove blockages in the suction
nozzle, suction tube, suction hose
or filters.
Replace the paper or fleece dust bag.
Clean or replace the filters.
Empty the dust tank, refer to
Empty
the tank
under
Operating
instructions.
Check for proper installation of the
filters.
Suction capacity
decreases
Vacuum stops
running
Thermal overload has been tripped:
1. Turn the vacuum off and
disconnect vacuum cleaner from
power source.
2. Empty the canister, if needed.
3. Allow the unit to cool.
4. Plug the power cord into an
appropriate outlet and turn on/off
switch to the ON position ( I ) to
test. If vacuum will not restart
call 1-888-899-0146
Ensure filters are not damaged;
replace if necessary.
Ensure filter seals are in place and
are secure.
Check for proper installation of the
filters.
Dust comes out
while vacuuming
ENGLISH
