5
CAUTION:
To reduce the risk of hearing loss, wear ear
protectors when using the vac for extended
hours or when using it in a noisy area. The unit
is ready for dry vacuuming.
After plug the power cord into the wall
receptacle, turn the unit “ON” by pushing the
switch position with 1 embossing straps is
the “ON” position.
ON
OFF
1. The filter must always be in correct position to
reduce the risk of leaks and possible damage
to vac. Make sure that the filter is completely
covering the filter cage. Make sure there are
no gaps between the filter and the lid. It is
very important to assemble the filter to the
cage without any possible leaks or tears.
Any leaks will allow the picked up debris
to be blown out of the blowing port and back
into the surrounding environment.
DRY PICK-UP
4. To clean the cartridge filter, shake or brush off
excess dirt or rinse (from the inside of the filter)
with water, dry completely (approximately 24
hours) and re-install.
2. When using the vac to pick up fine dust,
it will be necessary to empty the dust tank and
clean or replace the filter at more frequent
intervals to maintain peak vac performance.
1. With the power head in an upside down position,
slide the cartridge filter down over the lid cage,
push the filter seals against the power head.
2. Turn the knob on filter retainer clockwise to
tighten, the filter into place.
3. To remove the filter for cleaning, turn the filter
knob counter clockwise till feel the tactile and
auditory cue, and make sure the knob arrow
align with the "Unlock" icon on the filter cap,
then slide the cartridge filter off the lid cage.
then grasp the step of knob tightly with fingers
to pull the cartridge filter out off the cage.
The cartridge filter can be used for wet or dry
pick-up, installation is the same for both.
INSTALLING THE CARTRIDGE FILTER
NOTICE:
A dry filter is necessary to pick up dry material. If
use the vac to pick up dust when the filter is
wet, the filter will clog quickly and be very difficult
to clean. If the filter gets wet, replace it before
continuing to do dry pickups.
NOTICE:
If the filter has been used for wet pick-up, it must
be cleaned and dried before dry pick-up.
Lock
1. Slide the cardboard collar opening firmly onto
the vacuum port deflector until it stops against
the deflector wall.
2. Position the bag so that it is distributed around
the inside of the tank.
3. Replace and secure the power head onto the
tank.
WET PICK-UP
INSTALLING THE DISPOSABLE FILTER
BAG
Remove all dirt and debris found in the tank.
The vacuum requires only a minimum of
conversion when going from dry to wet pick up.
Remove the dry use filter from the vacuum. A
clean cartridge filter may used for vacuuming
small amounts of liquids. For best results when
vacuuming large quantities of liquid, remove the
cartridge filter. When vacuuming liquids
containing debris, it is recommended purchas-
ing a foam filter and install over the filter cage.
The foam filter may be purchased by visiting our
website at www.dewalt.com, contacting our
customer service department, or purchasing at
the local D
E
WALT distributor. When picking up
large amounts of liquid, it is recommend to
remove the cartridge filter. If the filter is not
removed, it will become saturated and misting
may appear in the exhaust.
ENGLISH
Disposable
dust bag
