7
English
guide roller bracket (D). Retighten the ball stop bolts. Do not over-
tighten the bolts.
WARNING:
1) Make sure the hose reel is secure before each use.
2) Never connect to an air source that is greater than 250 PSI.
3) Inspect the air hose before each use to make sure there are
no leaks.
4) Do not wrap the hose around any parts of the body.
COMPRESSOR HOOK-UP
The hose reel includes a 1/2" x 4' lead-in hose for hooking up the
hose reel to your air source. Apply Teflon tape to the male threads
of the lead-in house and thread the non swivel end into the air hose
inlet (I). Thread and connect the other end into your air source.
Attach air tool or accessory to the air outlet of the air hose in the
hose reel.
OPERATION
Check the operation of the reel by slowly pulling out the hose. You
will hear a clicking noise.
LOCKING HOSE REEL
Pull out the hose slowly until the desire length of hose is reached,
allow it to retract after hearing a series of clicks.
UNLOCKING HOSE REEL
Pull out the hose slowly until the the clicking noise stops, allow it to
retract until the ball stop rests against the hose guide roller bracket.
DO NOT LET GO OF THE HOSE!
WARNING: Risk of Injury.
Do not let go of the hose when
retracting.
WARNING:
Always disconnect air tool or accessory attached to
the hose reel from air supply before making any adjustments and
changing accessories.
ADJUSTING RECOIL TENSION
1. Disconnect the air supply to the hose reel.
2 Pull out about 2 feet of air hose and lock in place (see locking
hose reel).
3. Remove the 2 piece ball stop by removing the 2 phillips head
screws, washers and nuts.
4. Feed the hose back through the hose guide roller bracket.
(Note:
keep the hose reel drum locked at all times).
5. To
increase
tension, pull the hose around the drum one time.
6. To
decrease
tension, unwrap the hose one time around the
drum.
7. Push the hose back through the hose guide roller bracket
and pull out the hose from the hose reel to check the tension.
