25
ENGLISH
MAINTENANCE
WARNING: To reduce the risk of serious
personal injury, turn unit off before making any
adjustments or removing/installing attachments
or accessories.
An accidental start-up can
cause injury.
Your
D
e
WALT
power tool has been designed to operate
over a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper
tool care and regular cleaning.
Filter Replacement
WARNING:
To reduce the risk of injury from
accidental starting, unplug power cord before
changing or cleaning filter. Your filter should be
cleaned often to maintain peak vac performance.
Important
: To avoid damage to the blower wheel and
motor, always reinstall the Clean Connect TM filter before
using the vac for dry pickups and wet pickups.
Important
: After cleaning, check the filter for tears or small
holes. Do not use a filter with holes or tears in it. Even a
small hole can cause a lot of dust to come out of your vac.
Replace it immediately.
Note:
Before installing the filter on the vac, clean the area
of the lid so that the filter will seal against the lid and stop
small particles from bypassing the filter bag. If the filter is
clean and not damaged, replace it on the filter cage. If it
cannot be reused,place a new filter over the filter cage.
Note:
Clean the filter in an open area. Cleaning should be
done outdoors and not in living quarters.
WARNING:
Do not remove filter cage and float. The
float prevents water from entering the impeller and
damaging the motor. The cage prevents fingers from
touching the moving impeller.
Lubrication
Your power tool requires no additional lubrication.
Cleaning
WARNING:
Blow dirt and dust out of all air vents with
clean, dry air at least once a week. To minimize the
risk of eye injury, always wear approved eye protection
when performing this.
WARNING:
Never use solvents or other harsh
chemicals for cleaning the non-metallic parts of
the tool. These chemicals may weaken the plastic
materials used in these parts. Use a cloth dampened
only with water and mild soap. Never let any liquid
get inside the tool; never immerse any part of the tool
into a liquid.
To keep your wet/dry vac looking its best, clean the outside
with a cloth dampened with warm water and mild soap.
To clean the tank:
1. Dump out debris.
2. Wash tank thoroughly with warm water and mild soap
3. Wipe out with dry cloth.
Storage
Before storing your vac, the dust tank should be emptied
and cleaned. The cord should be wrapped and hung on the
unit and the accessories should be kept in mesh bag so they
can be readily available. The vac should be stored indoors.
Accessories
WARNING:
Since accessories, other than those
offered by
D
e
WALT
, have not been tested with this
product, use of such accessories with this tool could be
hazardous. To reduce the risk of injury, only
D
e
WALT
recommended accessories should be used with
this product.
Recommended accessories for use with your tool are
available at extra cost from your local dealer or authorized
service center.
Repairs
The charger and battery pack are not serviceable.
WARNING:
To assure product SAFETY and
RELIABILITY, repairs, maintenance and adjustment
(including brush inspection and replacement) should
be performed by a
D
e
WALT
factory service center
or a
D
e
WALT
authorized service center. Always use
identical replacement parts.
Protecting the Environment
Separate collection. Products and batteries
marked with this symbol must not be disposed
of with normal household waste.
Products and batteries contain materials that can be
recovered or recycled reducing the demand for raw
materials. Please recycle electrical products and batteries
according to local provisions.
Fig. K
Fig. L
