43
English
FIG. 9
HH
II
KK
JJ
L
X
Vacuum Attachment
(Plunge Base Only, Fig. 9)
1. Remove the motor unit from the plunge base, see
Motor Quick
Release
.
2. Slide tab (HH, inset) on vacuum attachment into slot in plunge
base and snap tab (II, inset) into hole in plunge base.
3. Secure to base with supplied plastic washer (JJ) and thumb
screw (KK). Tighten thumb screw securely by hand.
4 Attach hose adaptor to vacuum attachment.
5. When using vacuum attachment, be aware of the placement of
the vacuum cleaner. Be sure the vacuum cleaner is stable and its
hose will not interfere with the work.
Set-up: Fixed Base (Fig. 1, 2)
INSERTING THE MOTOR INTO THE FIXED BASE (FIG. 1, 2, 10)
1. Open the locking lever (I) on the base.
2. If the depth adjustment ring (B) is not on the motor, thread the
depth adjustment ring (B) onto the motor until the ring is about
halfway between the top and bottom of the motor as shown.
Insert the motor into the base by aligning the groove on the motor
(G) with the guide pins (R) on the base. Slide the motor down until
the depth adjustment ring snaps into place.
NOTE:
Guide pin grooves (G) are located on either side of the
motor so it can be positioned in two orientations.
3. Adjust the depth of cut by turning the depth adjustment ring. See
Adjusting the Depth of Cut
.
4. Close the locking lever (I) when the desired depth is achieved.
For information on setting the cutting depth, see
Adjusting the
Depth of Cut
.
Set-up: Plunge Base (Fig. 1, 10, 11)
INSERTING THE MOTOR INTO THE PLUNGE BASE
1. Remove the depth adjustment ring (B) from the motor. It is not
used with the plunge base.
NOTE:
Snap depth adjustment ring
onto fixed base, when not in use, to prevent loss.
2. Insert the motor into the base by aligning the groove on the motor
(G) with the guide pins (R) on the base. Slide the motor down until
the motor stops on the motor stop (AA).
3. Close the locking lever (I).
