41
English
To adjust the subbase, follow the steps below.
1. Loosen but do not remove the subbase screws (FF) so the
subbase moves freely.
2. Insert the pin into the collet and tighten the collet nut.
3. Insert the motor into the base and clamp the locking lever on the
base.
4. Place the cone on the pin (Fig. 5A) and lightly press down on
the cone until it stops as shown in Figure 5B. This will center the
subbase.
5. While holding down on the cone, tighten the subbase screws.
Using Template Guides
The round subbase will accept universal template guides.
Recommended accessories for use with your tool are available at
extra cost from your local dealer or authorized service center.
NOTE:
The D-shape subbase does not accommodate template
guides and is designed to accommodate bits up to 1-3/8” (34.9 mm)
in diameter.
To Use Template Guides:
1. Center the subbase. See
Centering The Subbase
.
2. Install template guide (available as an accessory) on the subbase
and tighten securely.
Adjusting the Depth of Cut (Fig. 6)
1. Select and install the desired bit. See
Bit Installation and
Removal.
2. Assemble base to motor, ensuring base is attached to the depth
adjustment ring. Place router on the work piece.
3. Open the locking lever (I) and turn the depth adjustment ring (B)
until the bit just touches the work piece. Turning the ring clockwise
raises the cutting head while turning it counterclockwise lowers
the cutting head.
FIG. 6
I
B
H
B
H
4. Turn the micro adjustable scale (H) clockwise until the 0 on
the scale lines up with the pointer on the bottom of the depth
adjustment ring.
5. Turn the depth adjustment ring until the pointer lines up with
desired depth of cut marking on the micro adjustable scale.
NOTE:
Each mark on the adjustable scale represents a depth
change of 1/64” or .015” (0.4 mm) and one full (360º) turn of the
ring changes the depth 0.5” (12.7 mm).
6. Close the locking lever (I) to lock the base.
Using an Edge Guide (Fig. 7, 9)
An edge guide (model DNP618) is available from your local retailer or
service center at extra cost.
1. Remove the motor unit from the base unit, see
Motor Quick
Release.
2. Remove flat head screws (GG) from storage holes on edge guide.
