DeWalt DWOAS6PS, Инструкция по эксплуатации

Страница: 10 / 48

English
8
• Keep firm footing and balance. Do not overreach.
Overreaching can result in loss of balance or exposure to
hot surfaces.
• Keep all parts of your body away from any moving part.
• Do not, under any circumstance, use any attachment or
accessory on this product, which was not provided with
the product, or identified as appropriate for use with this
product in this instruction manual.
• Inspect pole saw before each use and after dropping or
other impacts. Ensure there are no significant defects
or damage.
Do Not Operate Pole Saw:
‑ while under the influence of alcohol, medication,
or drugs.
‑ in rain or in damp or wet areas.
‑ where highly flammable liquids or gases are present.
‑ if pole saw is damaged, adjusted incorrectly, or not fully
and securely assembled.
‑ if trigger does not turn pole saw on and off. Chain
must stop moving when you release trigger. Have
faulty switch replaced by authorized service center. See
Accessories under Maintenance .
‑ while in a hurry.
‑ while in a tree or on a ladder.
‑ while on aerial booms, buckets or platforms.
‑ during high wind or storming weather.
GENERAL SAFETY RULES
DANGER: Shock Hazard.
Serious injury or death from
electrocution if power lines are contacted. Never use
near any electrical source, wires, or power lines.
WARNING: For safe operation read and
understand owner’s manual. Wear face shield (and/
or safety glasses) and hard hat to protect against falling
debris. Always have a clear work area, retreat path, and
be aware of limb/branch location to avoid falling limbs
and debris. Keep bystanders 50 feet (15 m) away when
operating saw. To reduce the risk of electric shock do not
use on wet surfaces. Do not expose to rain. Store indoors.
• To protect yourself from falling branches do not stand
directly under the branch or limb being cut. This unit should
not be held at an angle over 60 ° from ground level.
• Keep the handles dry, clean, and free of oil.
• Before you start the unit, make sure the chain is not
contacting any object.
• Make sure the cutting chain has stopped before setting the
unit down.
Service
• Tool service must be performed only by qualified repair
personnel. Service or maintenance performed by
unqualified personnel could result in a risk of injury. Refer to
the
Maintenance section of this manual.
• When servicing a tool, use only identical replacement parts.
Follow instructions in the Maintenance section of this manual.
‑ face or dust mask (if working in dusty areas)
•
Wear heavy long pants and boots.
Do not wear
loose fitting clothing, short pants, jewelry of any kind, or
go barefoot.
• Secure long hair to prevent entanglement in any
moving parts.
• Before cutting, always provide the following:
‑ clear work area
‑ secure footing
‑ planned retreat path from falling limbs
• Inspect tree before trimming. Make allowance for branches
to fall freely to the ground.
• Do not use your pole saw to fell saplings.
While Operating Pole Saw
DANGER: To reduce the risk of electric shock
do no use on wet surfaces. Do not expose to rain.
Store indoors.
DANGER: Avoid Unintentional Starting
– with
battery installed, don’t carry appliance with with finger
on switch. Be sure switch is off when installing battery.
• The extension pole should exclusively be used with the
pole saw attachment. Only one extension pole should be
used with the pole saw attachment. Do not use more than
one extension pole. Do not use the extension pole with any
other attachments.
• Stay alert. Use common sense while operating the unit.
• Keep work area clean. Cluttered areas invite injuries.
• Always remove battery from pole saw when finished
cutting or when left unattended.
• Keep children, animals and bystanders at least 15 m away
from pole saw. Only pole saw user should be in work area.
• Do not use the pole saw to cut down trees.
• Do not grasp the exposed saw chain when picking up or
holding the pole saw.
• Keep finger off trigger until ready to make cut.
• Before starting pole saw, make sure chain is not
touching anything.
• Keep all parts of body away from chain when pole saw
is running.
• Do not force pole saw while cutting. Apply light pressure.
It will do the job better and safer at the rate for which it
was intended.
• Carry pole saw from one place to another:
‑ with battery removed,
‑ fingers off/away from trigger,
‑ by holding pole at balance point, and
‑ with guide bar and chain to rear and with
scabbard attached.
• Do not cut small brush and saplings with the pole saw.
Slender matter may catch in the chain and be whipped
toward you. This could also pull you off balance.
• Do not operate in poor lighting.