11
• Apply only a gentle pressure to the tool. Do not exert side pressure on
the disc.
• Avoid overloading. Should the tool become hot, let it run a few minutes
under no load condition.
Proper Hand Position (Fig. 1, 4)
WARNING:
To reduce the risk of serious personal injury,
ALWAYS
use proper hand
position as shown.
WARNING:
To reduce the risk of serious personal injury,
ALWAYS
hold securely in
anticipation of a sudden reaction.
Proper hand position requires one hand on the side handle (C), with the other hand on
the body of the tool, as shown in Figure 1.
Switches
WARNING:
Hold the side handle and body of the tool firmly to maintain control of
the tool at start up and during use and until the wheel or accessory stops rotating.
Make sure the wheel has come to a complete stop be fore laying the tool down.
NOTE:
To reduce unexpected tool movement, do not switch the tool on or off while
under load conditions. Allow the grinder to run up to full speed before touching the
work surface. Lift the tool from the surface before turning the tool off. Allow the tool
to stop rotating before putting it down.
FIG. 4
G
5. Screw the threaded clamp nut (E) onto the spindle. The ring on the threaded
clamp nut must face towards the rubber backing pad.
6. Press the spindle lock button (A) and rotate the spindle (B) until it locks in
position.
7. Tighten the threaded clamp nut (E) with the hex key provided or a two pin
spanner.
8. Release the spindle lock.
9. To remove the rubber backing pad, loosen the threaded clamp nut (E) with the
hex key provided or a two pin spanner.
Fitting a Wire Cup Brush
Screw the wire cup brush directly onto the spindle without the use of the spacer and
threaded flange.
Prior to Operation
• Install the guard and appropriate disc or wheel. Do not use excessively worn
discs or wheels.
• Be sure the inner and outer flanges are mounted correctly.
• Make sure the disc or wheel rotates in the direction of the arrows on the accessory
and the tool.
OPERATIONS
WARNING: To reduce the risk of serious personal injury, turn off and unplug the
tool before making any adjustments or removing or installing attachments or
accessories.
Before reconnecting the tool, depress and release the paddle switch to
ensure that the tool is off.
An accidental start-up can cause injury.
WARNING:
Always observe the safety instructions and applicable regulations.
WARNING:
• Ensure all materials to be ground or cut are secured in place.
• Secure and support the workpiece. Use clamps or a vice to hold and
support the workpiece to a stable platform. It is important to clamp and
support the workpiece securely to prevent movement of the workpiece
and loss of control. Movement of the workpiece or loss of control may
create a hazard and cause personal injury.
Содержание DWE4000-XE
Страница 1: ...DWE4000 XE DWE4001 XE HEAVY DUTY SMALL ANGLE GRINDER INSTRUCTION MANUAL ...
Страница 2: ......
