DeWalt DW995K, Инструкция по эксплуатации

Страница: 11 / 20

9
makes the slot or “kerf” cut by the moving blade, fall to the right of the indicator. The
markings on the front of the foot plate are in increments of 5 mm (1/5").
FIG. 10
45 ˚
0 ˚
Cut Length Indicator (Fig. 11)
FIG. 11 The markings on the side of the foot plate show the
length of the slot being cut into the material at the full
depth of the cut. The markings are in increments of
5 mm (1/5").
Mounting and Adjusting the Rip Guide
(Fig. 12)
The rip guide (X) is used for cutting parallel to the
edge of the workpiece.
MOUNTING
1. Slacken the rip guide adjustment knob (Y) to
allow the rip guide to pass.
2. Insert the rip guide (X) in the foot plate (H) as
shown.
3. Tighten the rip guide adjustment knob (Y).
ADJUSTING
1. Slacken the rip guide adjustment knob (Y) and set the rip guide (X) to the desired
width. The adjustment can be read on the rip guide scale.
2. Tighten the rip guide adjustment knob (Y).
FIG. 12
X
Y
H
OPERATION
WARNING: To reduce the risk of serious personal injury, turn tool off and
disconnect tool from power source before making any adjustments or removing/
installing attachments or accessories. An accidental start-up can cause injury.
Proper Hand Position (Fig. 13)
FIG. 13
B
E
WARNING: To reduce the risk of serious
personal injury, ALWAYS use proper hand
position as shown.
WARNING: To reduce the risk of serious
personal injury, ALWAYS hold securely in
anticipation of a sudden reaction.
Proper hand position requires one hand on
the main handle (B), with the other hand on
the auxiliary handle (E).
Switching On and Off (Fig. 1)
For safety reasons the trigger switch (A) of
your tool is equipped with a lock-off button (M).
Press the lock-off button to unlock the tool.
To run the tool, press the trigger switch (A). As soon as the trigger switch is released,
the lock-off switch is automatically activated to prevent unintended starting of the
machine.