4
RELEASE BUTTON
FIG. 2
FIG. 3
•
An extension cord must have adequate wire size (AWG or
American Wire Gauge) for safety. The smaller the gauge number of
the wire, the greater the capacity of the cable, that is 16 gauge has
more capacity than 18 gauge. When using more than one extension
to make up the total length, be sure each individual extension con-
tains at least the minimum wire size.
Recommended Minimum AWG Size for Extension Cords
Total Extension Cord Length (feet)
25
50
75
100
125
150 175
Wire Gauge
18
18
16
16
14
14
12
•
The charger is ventilated through slots in the top and the bot-
tom of the housing. Do not place any object on top of charger or
place the charger on a soft surface that might block the ventilation
slots and result in excessive internal heat. Place the charger in a posi-
tion away from any heat source.
•
Do not operate charger with damaged cord or plug — have them
replaced immediately.
•
Do not operate charger if it has received a sharp blow, been
dropped, or otherwise damaged in any way; take it to an authorized
service center.
•
Do not disassemble charger; take it to an authorized service center
when service or repair is required. Incorrect reassembly may result in
a risk of electric shock, electrocution or fire.
•
To reduce risk of electric shock, unplug charger from outlet
before attempting any cleaning. Removing the battery pack will not
reduce this risk.
•
NEVER attempt to connect 2 chargers together.
•
The charger is designed to operate on standard household elec-
trical power (120 Volts AC). Do not attempt to use it on any other
voltage! This does not apply to vehiculat charger.
Chargers
Your battery can be charged in D
E
WALT 1 Hour Chargers, 15
Minute Chargers or Vehicular 12 volt charger. Be sure to read all
safety instructions before using your charger.
Consult chart on back cover for compatibility of chargers and
battery packs.
Charging Procedure
1 HOUR CHARGERS
1. Plug the charger into an appropriate power outlet.
2. Insert the battery pack into the charger, as shown in FIG.1,
making sure the pack is fully seated in the charger. The red
(charging) light will blink continuously indicating that the
charging process has started.
3. The battery pack will be fully charged in about 1 hour. The
completion of charge will be indicated by the red light remaining
ON continuously. The pack is fully charged and may be used at
this time or left in the charger.
TROUBLE INDICATORS: These chargers are designed to detect
certain problems that can arise with battery packs which would be
indicated by the red light flashing at a fast rate (and continuous
beeping for 15 Minute Chargers). If this occurs, re-insert battery
pack. If problem persists, try a different battery pack to determine if
the charger is OK. If the new pack charges correctly, then the
Содержание DW970
Страница 1: ......
