DeWalt DW902, Инструкция по эксплуатации

Страница: 11 / 32

English
7
4. The battery pack should be recharged when it fails to produce
sufficient power on jobs which were easily done previously. DO
NOT CONTINUE to use under these conditions. Follow the
charging procedure. You may also charge a partially used pack
whenever you desire with no adverse affect on the battery pack.
5. Under certain conditions, with the charger plugged into the
power supply, the exposed charging contacts inside the charger
can be shorted by foreign material. Foreign materials of a
conductive nature such as, but not limited to, steel wool,
aluminum foil, or any buildup of metallic particles should be kept
away from charger cavities. Always unplug the charger from the
power supply when there is no battery pack in the cavity. Unplug
charger before attempting to clean.
6. Do not immerse charger in water or any other liquid.
WARNING: Don't allow any liquid to get inside charger. Electric
shock may result. To facilitate the cooling of the battery pack
after use, avoid placing the charger or battery pack in a warm
environment such as in a metal shed, or an uninsulated trailer.
CAUTION: Never attempt to open the battery pack for any rea-
son. If the plastic housing of the battery pack breaks or cracks,
return the battery pack to a service center for recycling.
Battery Insertion and Removal
To insert the power pack into your flashlight, slide it into the end of
the light until it snaps into place. To remove the power pack,
depress the release buttons shown and withdraw the power pack.
Switch
To turn the light on, slide the switch forward. To turn it off, slide the
switch back.
Pivoting Head (Figure 2)
Your flashlight has a pivoting head. To convert your light to a right
angle model, grasp the front end of the light forward of the switch
and hold the back end firmly. Twist the front end clockwise (as
viewed from the lens) until the head pivots 90 degrees and clicks
into place. To return the head to a straight position, rotate the head
(as viewed from the lens) counterclockwise until it clicks into the
straight position.
Replacing the Light Bulb
Worklight Cat. No. Replacement Bulb Cat. No.
DW902 DW9023
DW904 DW9043
DW906 DW9063
DW908 DW9083
To replace the light bulb, first unscrew the lens holder. Pull the bulb
out of the spring, and insert a new bulb. Reinstall lens holder.
NOTE: Do not look directly into the flashlight beam.
FIG. 3 BATTERY RELEASE
BUTTON
SPARE BULB
STORAGE
FIG. 2