DeWalt DW830, Инструкция по эксплуатации

Страница: 23 / 88

17 en - 5
E N G L I S H
230 0 - 2.0 6 6 6 6 6 6
2.1 - 3.4 6 6 6 6 6 6
3.5 - 5.0 6 6 6 6 10 15
5.1 - 7.0 10 10 10 10 15 15
7.1 - 12.0 15 15 15 15 20 20
12.1 - 20.0 20 20 20 20 25 -
Voltage drops
Inrush currents cause short-time voltage drops.
Under unfavourable power supply conditions, other
equipment may be affected.
If the system impedance of the power supply is lower
than 0.25 ø , disturbances are unlikely to occur.
Assembly and adjustment
Prior to assembly and adjustment always
unplug the tool.
Mounting and removing the guard
DW830 - Mounting (fig. B1 & C1)
• Place the angle grinder on a table, spindle up.
• Align the lug (6) with the slot (7) in the bracket.
• Press the guard (8) down and turn it in the
direction of the arrow (fig. B1).
The guard locking pin (9) prevents the
guard from coming loose.
DW830 - Removing (fig. B1 & C1)
• Hold the tool in your hand.
• Rotate the guard (8) in the direction of the arrow
(fig. C1).
• Use a screwdriver to press the locking pin (9) in
the slot.
• Release the guard.
DW840/DW841 - Mounting (fig. B2 & C2)
• Place the angle grinder on a table, spindle up.
• Align the lugs (6) with the slots (7).
• Press the guard (8) down and turn it in the
direction of the arrow (fig. B2).
• Securely tighten the screws (9).
DW840/DW841 - Removing
• To remove the guard, proceed in reverse order.
Mounting and removing a grinding wheel or
cutting disk (fig. D & E)
• Place the tool on a table, guard up.
• Fit the spacer (11) correctly onto the spindle (10).
• Place the grinding wheel or cutting disk on the
spacer.
• Screw the threaded flange (12) onto the
spindle (10).
• Press the spindle lock (5) and rotate the grinding
wheel or cutting disk until it locks in position.
• Tighten the threaded flange using the two-pin
spanner (13) supplied.
• Release the spindle lock.
• To remove the grinding wheel or cutting disk,
loosen the threaded flange using the two-pin
spanner (while the spindle lock is engaged).
Fitting a wire cup brush
• Screw the wire cup brush directly onto the spindle
without using the spacer and threaded flange.
Mounting the side handle (fig. F)
• Screw the side handle (4) tightly into one of the
holes (14) on either side of the gear case.
Instructions for use
• Always observe the safety instructions
and applicable regulations.
• Ensure all materials to be ground or cut
are secured in place.
• Apply only a gentle pressure to the tool.
Do not exert side pressure on the
grinding wheel or cutting disk.
• Avoid overloading. Should the tool
become hot, let it run a few minutes
under no load condition.
Prior to operation:
• Install the appropriate guard and disk or wheel.
Do not use excessively worn disks or wheels.
• Be sure the spacer and threaded flange are
mounted correctly.
• Make sure the disk or wheel rotates in the
direction of the arrows on the accessory and the
tool.