DeWalt DW7440RS, Инструкция по эксплуатации

Страница: 7 / 28

6
English
TO REMOVE THE SAW FOR
E
K
L
CARRYING OR FOR USE
WITHOUT THE STAND
1. Reach around the sides
of the saw and grasp the
release levers (E).
2. Pull up slightly to clear
the beam and tilt the saw
toward you to carry.
TO REATTACH THE SAW
AND SAW MOUNTING
BRACKETS TO THE STAND
1. Grip the table saw table
as shown while facing the
front of the saw.
2. Position the left-hand side mounting bracket into the locator clip.
3. When the front concave lip of both mounting brackets are
engaged with the front round edge of the beam, pivot the
saw back and down allowing the release levers (E) to click
into place on the rear beam. Rock the saw gently to verify the
mounting brackets are locked onto the beams.
4. If the handle (K) has been extended, pull the handle lock (L)
down to release the handle and then slide the handle in for
storage or saw usage.
TO ATTACH D
E
WALT DW745 TABLE SAW TO THE SAW
MOUNTING BRACKETS
1. Remove the front feet bolts and the front rubber feet from the
DW745 table saw.
2. Remove the rear feet from the rear frame bar of the saw.
3. Retain these components for future use.
4. Feed a hex head bolt with flat washer installed through each of
the four holes in the frame bars where the removed front and
rear feet were previously installed. Secure each location with a
flat washer, lock washer and nut provided.
WARNING: To reduce the risk of personal injury, NEVER use the
table saw with the handle extended. An extended handle creates an
unsafe work area.
WARNING: To reduce the risk of personal injury, do not hang
objects from the handle. The stand may tip when downward force
is applied.
Transporting the Saw on the Stand
COLLAPSING THE STAND FOR TRANSPORT
1. Place one hand under the leg support and hold the legs slightly
off the ground.
2. Depress the leg release lever (F) with the other hand then push
the leg under the beam on the stand. Repeat the operation on
the second leg of the stand and rest the stand on wheels.
M
K
L
F
3. Repeat with the other end of the stand.
4. Pull the extendable handle (K) out of the side of the stand. The
spring-loaded handle lock (L) will lock the handle into position for