English
11
WARNING:
Avoid climb-cutting (cutting in direction
opposite than shown in Figure 10).
Climb-cutting increases the
chance for loss of control resulting in possible injury. When climb-
cutting is required (backing around a corner), exercise extreme
caution to maintain control of router. Make smaller cuts and remove
minimal material with each pass.
Using the Edge Guide (Fig. 11, 12)
The DW6913 edge guide, available at extra cost, will increase the
versatility of your router. Assemble the guide as shown in Figure 12.
When it’s fully assembled, insert the two bars through the holes in
the router base as shown. Adjust as needed for parallel routing.
The guide will adjust in, all the way to the cutter. In some cases the
plastic slides on the guide will interfere with the cutter if they are not
loosened and pushed back to provide clearance. Loosen the two
screws on each slide and adjust it accordingly.
FIG. 11
electronic
S
FIG. 12
A fine adjust feature is included on the edge guide and is operated
by rotating the fine adjust knob (S). Turn the knob clockwise to move
the guide in (closer to the bit). Turn the knob counterclockwise to
move the guide out (away from the bit).
Template Guide
FIG. 13
T
Adapter (Fig. 13)
Your router comes equipped with a
template guide adapter (T) and two
mounting screws. Put these away in
a safe place for future use.
Connecting a Dust
Extractor (Fig 14)
U
V
W
FIG. 14
The dust extractor adapter
consists of the body (U), the
cover (V), and the hose guide
(W). Assemble as follows:
1. Slide the cover onto the
main body and let it click
into place.
2. Connect a dust extractor
hose to the outlet.
3. Loosen the screw on the
top cover of the router and
secure the hose guide in
place.
4. When using dust extraction, be sure that the vacuum cleaner is
out of the way and secure so that it will not tip over or interfere
with the router or workpiece. The vacuum hose and power
cord must also be positioned so that they don’t interfere with
the router or workpiece. If the vacuum cleaner or vacuum hose
cannot be positioned properly, it should be removed.
MAINTENANCE
WARNING: To reduce the risk of injury, turn unit off and
disconnect it from power source before installing and
removing accessories, before adjusting or when making
repairs.
An accidental start-up can cause injury.
