• Only use air hose that is rated for a maximum working
pressure of at least 150 PSI (10.3 Bar) or 150% of the
maximum system pressure, which ever is greater.
(Fig. D)
• Do not use bottled gases to power this
FIG. e
FIG. F
FIG. G
tool.
Bottled compressed gases such as
oxygen, carbon dioxide, nitrogen,
hydrogen, propane, acetylene or air are
not for use with pneumatic tools. Never
use combustible gases or any other
reactive gas as a power source for this tool.
Danger of explosion and/or serious
personal injury may result. (Fig. E)
• Use couplings that relieve all pressure
from the tool when it is disconnected
from the power supply.
Use hose
connectors that shut off air supply from
compressor when the tool is disconnected.
(Fig. F)
• Disconnect tool from air supply when
not in use. always disconnect tool
from air supply and remove fasteners
from magazine before leaving the
area or passing the tool to another
operator. Do not carry tool to another
work area in which changing location
involves the use of scaffoldings, stairs,
ladders, and the like, with air supply
connected. Do not make adjustments,
remove magazine, perform maintenance or clear jammed
fasteners while connected to the air supply.
If the contact trip is
adjusted when the tool is connected to the air supply and nails are
loaded, accidental discharge may occur. (Fig. G)
• Connect tool to air supply before loading fasteners, to
prevent a fastener from being fired during connection.
The
tool driving mechanism may cycle when tool is connected to
the air supply. Do not load fasteners with trigger or contact trip
depressed, to prevent unintentional firing of a fastener.
• Do not remove, tamper with, or
FIG. h
FIG. I
FIG. j
otherwise cause the tool, trigger, or
contact trip to become inoperable.
Do not tape or tie trigger or contact trip in
the on position. Do not remove spring
from contact trip. Make daily inspections
for free movement of trigger and contact
trip. Uncontrolled discharge could result.
• Inspect tool before use. Do not
operate a tool if any portion of the tool,
trigger, or contact trip is inoperable,
disconnected, altered, or not working
properly.
Leaking air, damaged parts
or missing parts should be repaired or
replaced before use. (Fig. H)
• Do not alter or modify the tool in any
way.
(Fig. I)
• Always assume that the tool contains
fasteners.
• Do not point the tool at co-workers
or yourself at any time.
No horseplay!
Work safe! Respect the tool as a working
implement. (Fig. J)
English
2
9R208191_DW325PL_DW325PT_DEWALT, FRAMING NAILER(LPF).indd 2
11/14/14 3:06 PM
Содержание DW325PL
Страница 2: ...9R208191_DW325PL_DW325PT_DEWALT FRAMING NAILER LPF indd 2 11 14 14 3 06 PM ...
Страница 28: ...Français 26 9R208191_DW325PL_DW325PT_DEWALT FRAMING NAILER LPF indd 26 11 14 14 3 06 PM ...
Страница 44: ...Español 42 9R208191_DW325PL_DW325PT_DEWALT FRAMING NAILER LPF indd 42 11 14 14 3 06 PM ...