DeWalt DW065E, Руководство пользователя

Страница: 4 / 28

4
of Directive 1999/S/EC. Please contact DeWalt for DoC.
Battery Safety
WARNING: Batteries can explode or leak and
cause serious injury or fire. To reduce the risk:
ALWAYS follow all instructions and warnings
on the battery label and package.
DO NOT short any battery terminals.
DO NOT charge alkaline batteries.
DO NOT mix old and new batteries. Replace
all of them at the same time with new
batteries of the same brand and type.
DO NOT mix battery chemistries.
DO NOT dispose of batteries in fire.
ALWAYS keep batteries out of reach of
children.
ALWAYS remove batteries if the device will
not be used for several months.
NOTE: Ensure that the recommended
batteries are used.
NOTE: Ensure the batteries are inserted in the
correct manner, with the correct polarity.
Setup (Load Batteries)
1.
Locate the battery compartment latch on the back
of the DW065E tool (Figure B #2).
2.
Using your finger, pull the latch up to unlock and
remove the battery door (Figure C #1 and #2).
3.
Insert two AAA batteries, making sure to position
the - and + ends of each battery as noted inside
the battery compartment (Figure C #3).
4.
Slide the pins at the bottom of the battery door
into the notches in the battery compartment (Figure
C #4).
5.
Push the battery door down until it snaps in place
(Figure C #5).
When the tool is ON, the battery level appears in the
display window (Figure E #1).
Operation
Measuring the Distance to a Wall or Object
1.
Click (Figure A #3) to turn on the tool.
2.
Point the laser at the top of the tool (Figure A #1)
toward the wall or object whose distance you need
to measure (Figure D #1).
3.
Click to measure the distance from the bottom
of the tool to the wall or object (Figure D #2).
4.
At the bottom of the display window (Figure A #2),
view the current measurement (Figure E #3).
To take a new measurement, click to move the
current measurement up to the previous line on the
display window (Figure E #3). Then repeat steps 2-4.
Measuring Distances Continuously
To take a series of measurements as you move
around, change to Continuous Measure mode.
1.
Click (Figure A #3) to turn on the tool.
2.
Point the laser at the top of the tool (Figure A #1)
toward the wall or object whose distance you need
to measure (Figure D #1).
3.
Click and hold for 4 seconds to turn on the
Continuous Measure mode.
4.
At the bottom of the display window (Figure A #2),
view the current measurement (Figure E #3), which
will keep changing as you move the tool.
5.
To take the current measurement (from the
bottom of the tool to the wall or object) and exit
Continuous Measure mode, click (Figure E #3).
To take a new measurement, click to move the
current measurement up to the previous line on the
display window. Then repeat steps 2-5.
Measuring Area
You can measure the area of a wall, floor, or object.
1.
Click (Figure A #3) to turn on the tool.
2.
Click to show on the display window
(Figure E #4).
3.
Measure the width .
• Point the top of the tool at one side of the
target (wall, floor, or object).
• Position the bottom of the tool at one end of the
target and point the laser dot across the width
(Figure F #1).
• Click to display the width measurement at
the top of the display window.
4.
Measure the length .
• Position the bottom of the tool at one end of the
target and point the laser dot across the length
(Figure F #2).